|
|
| << BUILDING ALL |
Here you are the program that you'll need for use the PSX pad:
DirectPad 5.0 (Windows 9x/ME)
Instalando el controlador DirectPad
- Get the newest DirectPad drivers above and unzip it to a temp directory anywhere, ei., C:\DPAD.
- Once the pad and the DB-25 connector are connected to the parallel port, Open the Control Panel and double click on Games Controllers.
- Click on Add... then Add Other... click on Have Disk... and then browse to when you unziped it. (C:\DPAD) Click OK a couple of times then Finish to complete the install of the driver.
- For me I had to click Add... again then select DriectPad Pro Force Feedback Controller and ok to add it.
- It should now be listed in the section with your other controllers.
- Now to configure the driver to use it with the PSX pad.
- On the Configure tab select the Controller Type you want (PSX digital or PSX left/right Analog)
- You can go through the other settings and tabs to completely change everything but for the first time you should leave most of it alone. Maybe except to Calibrate the controller
Remember: to only select the Force Feedback driver if you have the 9v power addon other wise select the DirectPad Pro Controllerdriver.
NOTE: The arcade emulators MAME (DOS version) and RAINE support the PlayStation pad directly. For use with MAME, add to the end of the command line -joy psxlpt1 (if you have the pad connected to parallel port 1). With Raine it's more simple, start the emulator and go to Control Setup and then Joystick Select.